Die deutschsprachige HPI Baja Community

Endlich mal wieder was neues aus dem Hause RPM für den Baja....

Quelle zum nachlesen: KLICK Mich Sanft....

HBZ hat jetzt geile chrom Querlenker im Angebot - das wäre doch für Chrom Fanatiker was tolles
Hier der Link: Drück mich sanft

Salve hab da grad zufällig gesehen dass der Andre jetzt auch das Reedcase und den passenden OBR Satz verkauft

TS Reedcase

OBR 30,5 Fullmod

find ich garnich mal so dumm dass man es jetzt auch bei und in deutschland bekommt

greetz

In München (Conrad Filiale München Tal) steht jetzt ein Rollen-Prüfstand für RC Modelle.

Quelle: http://www.modellbau-club.de/

Das sollte dann wohl sowas sein:



Wer kommt aus der Gegend und checkt da mal ein?

Original Text:

IRP Dual Servo Steering System

Brief description :

This is a dual servo steering system that does not require the use of a different top plate it works with the stock plate or the turtle top plate and so far as i can tell the OFF Lipo plate as well, will know more on the OFF soon.

The advantages are obvious, you get a servo dedicated to each tie rod, gain the room of the old servo set up, and mainly, the slop is all gone in the current steering set up.
there is no more one side turning better than the other, and i utilized as much of the stock locations as possible. this was a bloody war, as the area to work with is very limited.

The system is designed around the standerd size servo's, Hitec specifically , but pretty much any standerd size will work. the test unit in my rigs used the HS645mg servos. if you want more there are plenty of options out there...if you feel you need it there is the possibility of over 800oz/in.

What is included in the system, you will receive the top mounting plate,dual servo plate,a set of IRP system specific Turnbuckles and stand offs, Y-harness, 2 pre-drilled servo savers ( hitec spline), and all the mounting hardware.
****Servos are NOT INCLUDED....*****

For those of you that have the IRP turnbuckles there will be a seperate kit at a reduced price.

I tried my absolute best to make this system compatable with stock tie rods and all after market tie rods, including my own, but unfortunatly that just was not possible. when moving the attachment point inboard for the new system this made it impossible for anything but a special length tie rod.. i tried guys...

****NOTE****
As of this moment this system will NOT work with FLM exteneded a-arms, i should have that all worked out before releasing the system to the distributors...

Installation is pretty straight forward.
remove the radio box, and all stock steering components.
assemble the new steering unit on the bench, including the inner tie rod...[Weiterlesen]